Euroboor ECO.100/4, Руководство пользователя

Страница: 9 / 14

9
4-speed Manual Gearbox
The ECO.100/4 is equipped with a 4-speed gearbox. The two gear switches makes it possible to choose 4 manual
speeds. Also does the ECO.100/4 have a electronic speed adjustment so every wanted speed can be selected.
Important is that the closest mechanical gear is selected first and after that the speed can be decreased by the
electronic adjustment. Therefore, always try to keep the electronic speed wheel above 50% to prevent the armature
to build up heat due low running speed.
600rpm: left switch up, right switch down
For twist drills and hole cutters till 25mm
370rpm: left switch up, right switch up
For hole cutters 25-50mm
175rpm: left switch down, right switch down
For hole cutters 50-75mm
110rpm: left switch down, right switch up
For hole cutters 75-100mm and tapping.
("left" and "right" is seen from front of motorunit)
Note that the mentioned cutter sizes is only a indication. Depending on variables as the condition of the used cutter,
hardness of material or if oil is used the best drilling speed can be different as mentioned above.
To select other gear, turn off motorunit and main power. Push the black switch on the side of the gearbox and slide
to other position. A slight turn of the output shaft by hand while sliding the black switch to the other position can be
necessary to line up the gears inside. Proof that the gear is locked if the black switch comes back to front.