www.euroboor.com
9
1.2 Specific safety information
WARNING:
This tool is intended to function as Electric Band Saw Machine. Read all
safety warnings, instructions, illustrations and specifications provided with this tool.
Failure to follow all instructions listed below may result in electrical shock, fire and
serious injury.
Safety instructions
1.
Fully assemble your band saw machine before operation.
2.
Secure your workpiece properly. Work should be clamped to avoid possible movement
and pinching as the cut nears completion.
3.
Please do the following safety checks before you start using the machine.
a.
Always check if all bolts, screws and clamps are fully tightened. Tighten loose
bolts before use. If bolts, screws or clamps are missing, please refer to your
EUROBOOR dealer and have these replaced.
b.
Always check if the saw band can run freely before you start working with the
machine. Have the Electric Band Saw Machine serviced by qualified repair
personnel at your EUROBOOR dealer, if the saw band cannot run freely or
vibrates heavily.
c.
Check the saw band for cracks or other damage before operation. Do not use
Saw band when it is damaged or deformed.
d.
Check if your workpiece is properly secured, using the machine’s clamp.
e.
Check if the saw band of the machine is not contacting the workpiece before
the machine is turned on.
4.
Turn the machine on, but allow the motor to come up to full speed before you start
cutting.
5.
Lower the saw band onto the material firmly.
6.
Wait for the saw band to come to a full stop before making adjustments to the machine
or removing / securing the workpiece.
7.
Always shut off and unplug machine before servicing or adjusting the machine.
8.
Save the instructions manual and warning labels at all times.
