www.euroboor.com
20
4. Using the Air Die Grinder
4.1 Air supply system
For using this tool the following air supply system layout is recommended:
Also
take note
of the following:
1.
Make sure that the air compressor being used for the air tool operation supplies the
correct output (SCFM).
2.
Have the tool in the “off” position when connecting the tool to the air
supply.
3.
Use 90 PSI / 6.3 Bar air pressure while running the tool. Using a different air pressure
may result in reduced performance of the grinder.
4.
Drain water from the air compressor tank daily together with any condensed water in
the air hoses. Water in the air supply system can result in reduced performance and/or
damage.
5.
Clean the air inlet filter weekly. Unclean air can result in reduced performance, faster
wear and/or damage.
