OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
cont.
Changing & Cleaning the Dust Cup
Filter (cont)
4. Empty the dust from the dust cup
container. (See fig. 10)
5. Rinse the dust cup filter in cold water,
and then wait until it dries completely
before replacing it back into the dust
cup container. Do
not
use a washing
machine to clean the dust cup filter.
Do not use a hair dryer to dry it.
Air
dry only.
6. To empty liquids from the dust cup,
follow same instructions as above. Do
not let liquids in dust cup go over the
"MAX"
level on the dust cup. (Fig. 11
& Fig. 12)
7. Replace the separator housing and the
dust cup filter carefully into the dust
cup compartment.
NEVER operate
vacuum cleaner without the
separator housing and the dust cup
filter in place.
8. Attach the dust cup container to the
cordless vacuum.
Using Your Cordless Wet/Dry
Vacuum
1. Remove the vacuum cleaner from
the charging base
2. To start the unit, push the "On/Off"
switch to the "On" position.
3. To stop the vauum cleaner, slide
the "On/Off" switch to the "Off"
position.
Crevice Tool
A crevice tool is provided
for cleaning narrow, hard
to reach places.
Convertible Brush
A convertible brush is
provided for cleaning
upholstery, furniture,
etc.
Squeegee Nozzle
A squeegee nozzle is
provided for picking up
any liquid spills.
Fig. 6
Assembly (cont.)
4. To use the extension hose with
convertible brush, crevice tool or
squeegee nozzle, push the
smaller end of extension hose
into the suction hole, then
push the selected
accessory into the
other end. (Fig. 6)
IMPORTANT: WET PICK-UP
When using this vacuum for wet pick-up,
NEVER
fill past the "
MAX
" level mark on the
dust cup housing. Maximum capacity
(liquid) is 6 US Fl. Oz. (180 ml).
Never
tip
the unit upward past horizontal when
vacuuming liquids. Keep suction inlet
pointed downward. Always empty the dust
cup after using the vacuum to pick up
liquids.
Assembly
Note: Dust cup filter and separator
must always be used when
operating the hand vacuum.
1. To open the dust cup compartment,
push the dust cup release button
and remove the dust cup
container. (Fig. 2)
2. Verify that the dust cup filter and
the separator housing are inside,
then re-attach the dust cup
container to the wet/dry hand
vacuum. (Fig. 3 & Fig. 4)
Before Use
1. This cordless wet/dry hand vacuum is
powered by rechargeable nickel-
cadmium batteries. Before using the
vacuum, charge the vacuum cleaner
for a minimum of 16 hours.
NOTE: Ensure that the On/Off
switch is in the “Off” position
before charging.
NOTE:
Peak performance may only
be realized after the unit has been
charged and discharged two (2) or
three (3) times.
Fig. 2
IMPORTANT:
To maintain peak
performance of your cordless hand
vacuum, it is recommended that the
unit be fully discharged, then
completely re-charged at least once a
month.
Fig. 3
2. Store the vacuum cleaner in the
charging base when not in use so that
it is always charged and ready to
use.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Charging Your Vacuum Cleaner
1. Place the charging base near an
electrical power outlet (120 V., 60 Hz.)
and plug in the charging adapter's jack
into the charging base.
2. Plug the charger into wall outlet.
3. Place the unit in the charging base. The
charging indicator light will shine red to
indicate that the vacuum cleaner is
properly positioned in the charging base
and that the unit is being charged.
(See fig. 1)
NOTE: Ensure that the On/Off
switch is in the "Off" position
before charging.
3. To attach the convertible brush,
crevice tool or squeegee nozzle to
the wet/dry hand vacuum, push the
attachment into the suction hole in
the front of the dust container.
(Fig. 5)
Fig. 5
Fig. 4
NOTE:
When vacuuming up liquids,
ensure that you do not go over the
"MAX" level on the dust cup. Capacity
is 6 US Fl. Oz. (180 ml.).
NOTE:
It is recommended that the dust
cup filter be replaced every three (3)
months to ensure peak performance of
the unit.
Charging
Receptacle
Charging
Jack
Fig. 1
Changing & Cleaning the Dust Cup Filter
To achieve the best performance, empty
the dust cup container and clean the
dust cup filter after each use.
1. To remove the dust cup container,
press down on the dust cup release
button and pull off the dust cup
container. (Fig. 7)
2. Pull out the dust cup filter. (Fig. 8)
3. Pull out the separator housing. (Fig. 9)
CAUTION:
The suction hole must be
open and free of any obstructions at all
times. Otherwise, the motor will
overheat and could become damaged.
3
4
