47
EN
Adjusting the speed
Roll the on/off and speed control thumb wheel (2) to adjust the desired speed 1-5.
Work Mode (Fig.7)
∫ This Leaf blower/vacuum contains two operation mode, Blowing and Suction.
∫ Switch the function knob of lever blower / vacuum to set the blowing / suction operating
mode.
∫ In Fig.7 position A engages to the suction operating mode; position B engages to the
blowing operating mode.
Blowing operating mode
∫ You get the optimal result when you use the blower with a separation distance to the
ground of 5-10cm.
∫ The collection bag does not have to be fitted in when working on blower mode.
∫ Begin to work with the highest blowing power /speed, in order to rapidly pile up the
leaves lying ground, select a lower blowing speed to compact the previously piled up
leaves.
∫ Before blowing, loosen leaves adhering to the ground with a broom or rake.
∫ In very dry conditions, lightly moisten the ground to reduce dust exposure.
∫ The wheels at the end of the lower tube make it easier to work on flat surfaces.
∫ Hold the appliance by two handles when working.
Suction operating mode
∫ All tubes must be correctly mounted before starting the appliance.
∫ The collection bag must be fitted in suction mode.
∫ Make sure the volumes of leaf materials sucked in at one time are not too large. This will
avoid clogging of the tubes and blockage of the impeller.
∫ To reduce wear on the collection bag, do not drag it along the ground while working.
Emptying the collection bag
WARNING! Switch OFF the appliance and remove the battery pack before emptying
the collection bag.
WARNING! Wear a mask!
∫ Remove the collection bag by pressing the collection bag release (6).
∫ Open the zipper located on the rounded section of the collection bag (7) and empty the
collection bag (7).
∫ Close the zipper and mount the collection bag again. Make sure the collection bag zip is
fully closed before restarting the appliance.
