Eureka Customer Service HELPLINE 1-800-282-2886
6
Easy assembly
1
.
Slide battery onto hand vacuum
until firmly attached (Fig. 1).
2
.
Slide wand onto hand vacuum
until it clicks (Fig. 2).
3
.
Push wand into motorized floor
nozzle until it clicks (Fig. 3).
How to charge battery
and store accessories
• Place assembled vacuum cleaner
on wall mount.
• Plug charger into power outlet and
then into charger port on handle
(Fig. 5).
• Loop charger cord into clips on
sides of wall mount.
• Snap tool(s) into tool storage areas
(Fig. 5).
Battery indicator lights show
level of charge
(Fig. 5)
:
A. Fully charged
B. Half charged
C. Low power
• Indicator lights stop blinking when
fully charged.
• Charge battery fully before using for
the first time. This may take up to
four hours.
How to install wall mount
• Choose location near power outlet.
Locate point high enough on wall to
allow wand and motorized floor
nozzle to hang freely.
• Place mount against wall and use
pencil to mark drill holes.
• Drill holes (with 1/4” bit) and insert
drywall anchors. Insert screws
through holes on mount and tighten
until firmly attached (Fig. 4).
1
2
3
4
5
Click!
Click!
C
B A
Drywall anchors
Cord
clip
Tool storage
Cord
clip
Tool storage
NEC120_02155120_WMT_rev1.qxp_Layout 1 12/11/17 11:17 AM Page 6