Eureka E51M, Инструкция по эксплуатации

Страница: 27 / 47

27
Follow the instructions below to rotate or replace the rear blade :

Remove the squeegee from the machine;

Remove the blade locking plate (see position 5) by unlocking the retainer (see position 3). This retainer is fitted with a
safety device that keeps it from opening involuntarily. To release the retainer, push the small lever (see position 1)
towards the outer part of the squeegee and then pull the big lever (see position 2) towards the rear part of the squeegee;

Follow the same procedure to remove the locking plate (see position 5) from the other end of the squeegee (see
position 4);

Remove the blade (see position 6);

Rotate the blade and mount it back so that a new edge is on the drying side;

Hook the locking plate (see position 4);

Hook the retainer (see position 3) and lock it into place.
REPLACING THE FRONT BLADE
Follow the instructions below to replace the front blade :

Remove the squeegee (see position 1) from the machine;

Use a 10-mm tubular nut driver (see position 2) and remove the 6 screws (see position 3) and the respective washers
(see position 4);

Remove the blade locking plate (see position 5);

Remove the blade (see position 6);

Rotate the blade and mount it back so that a new edge is on the drying side of the blade;

Put the blade locking plate (see position 5) back into place;

Put the 6 screws back into place (see position 3), including the respective washers (see position 4) and make sure not
to tighten the screws excessively causing the rubber blade to deform (swell).
CHECKING THE INSTALLATION OF THE SQUEEGEE BLADES
1
2
Once the squeegee blades are rotated or replaced, lay the squeegee onto a flat surface and check the following:

Make sure the rear blade (see position 2) is fitted correctly and levelled throughout its entire length. If the blade is not
fitted evenly, release the blade locking plate and re-position the blade so that it is levelled correctly against the floor.

Make sure the front blade (see position 1) is fitted evenly and check for any deformations due to tightening the screws
excessively. Also make sure the blade is raised 3 mm above the ground throughout its entire length.