Eureka Blaze Original, Инструкция по эксплуатации

Страница: 15 / 20

Troubleshooting
Problem Possible Reasons
There is little heat or no
heat.
Cross check thermostat dial
and look for any error in power
transmission.
Adjust thermostat dial to your
desired setting.
Set the thermostat dial to a
higher setting.
Remove excess water.
By moving to the right, adjust
the steam control lever to the
proper position.
Fill the water level up to the
MAX mark on the tank.
Use the iron’s self-clean
technology.
Press water spray button
repeatedly until air pressure
reaches the optimal level.
Give regular pauses between
each burst of steam.
Cord may be unplugged or thermostat
improperly set.
Thermostat dial is set at the OFF mark.
Repeated usage of vertical burst of steam or
the iron is not hot enough.
The iron is not hot enough.
The water is exceeding the MAX position mark.
Steam control lever is not set to the proper
position.
Clogged steam holes.
Not enough water in tank.
Not enough water in the water tank.
Lack of air pressure inside.
Steam has stopped or
there is leakage.
There is no flow of steam or
vertical steam is absent.
Water is leaking from
soleplate.
There is less steam.
No Water Spray
Solution
Fill the water level up to the
MAX mark on the tank.
13