Eureka Blaze Original, Инструкция по эксплуатации

Страница: 11 / 20

9
Self- Cleaning
If the water in your area is hard (contains excessive dissolved mineral),
self -cleaning should be done every two weeks.
1. Your iron should be unplugged before self-cleaning.
2. Using the Steam selector, set the steam level to mark ‘’0’’.
3. Fill the water tank to the MAX mark. Do not add any cleaning
solutions Inside the water tank.
4. Before plugging in your iron make sure that the thermostat dial is set
to MAX. Now allow the iron to heat up.
5. Indicator light will turn off once the iron reaches its optimal working temperature.
6. Once the indicator light goes off, turn the thermostat dial to OFF and
disconnect the iron from the power line.
7. Firmly hold the iron over the sink and press/hold the self- cleaning
button for several seconds.
8. Shake the iron back and forth while pressing the self-cleaning button.
Steam and boiling water will expel along with impurities and other
contaminants. (As shown on the following page)