10
11
3. Edge cleaning
RoboVac reduces its speed when it detects a wall and then follows the wall to ensure the
edge is cleaned thoroughly. In Edge mode, RoboVac will clean for 20 minutes and return to
the Charging Base.
Press on the remote control to start cleaning in Edge Mode.
4. Single Room cleaning
RoboVac intensively cleans one single room and stops after 30 minutes. Select this mode
only when one specific room needs to be cleaned. Make sure to confine RoboVac to the
room by closing the door.
Press on the remote control to start cleaning in Single Room Mode.
- RoboVac will return to the Charging Base automatically when the battery level
becomes low or when RoboVac finishes cleaning.
- By default, RoboVac starts in Auto cleaning mode when it is turned on.
BoostIQ™ Feature
When the BoostIQ™ feature is enabled, RoboVac will automatically increase the suction
power if it detects stronger power is needed to ensure the best clean. BoostIQ™ is ideal for
cleaning thicker carpets and hard-to-sweep messes, which will reduce the total cleaning time,
but increase the noise level. If the vacuuming noise caused by BoostIQ™ disturbs you, you can
disable this feature. This feature only works in Auto and Single Room cleaning modes.
To adjust the suction power level in Auto or Single Room cleaning mode, simultaneously
press and hold the
and buttons for 2 seconds; you will hear a series of beeps that
correspond to the suction power selected. Repeat to adjust the suction power level.
Suction Power Level
Beeps
Standard power
BoostIQ™
(Default, automatically switches between Standard and
Enhanced power)
Maximum power
When RoboVac starts cleaning in Auto or Single Room mode the next time, it will clean
according to the suction power level you previously selected.
2. Spot cleaning
RoboVac intensively cleans a specific area in a spiral pattern, useful if there is a concentrated
area of dust or debris. In Spot mode, RoboVac will stop cleaning after 2 minutes.
Press
on the remote control to start cleaning in Spot Mode.
