16
17
Pull off the old side brushes and snap the new ones into place.
Screw down the screws to fasten the side brushes.
Troubleshooting
Problem
Solutions
RoboVac cannot be
activated.
• Make sure the main power switch is in the ON position.
• Make sure the battery is fully charged.
• Replace the batteries (2 AAA) in the remote control.
• Make sure the remote control is within range (less than
6 ft/2 m from RoboVac).
• If you still have trouble, turn off the main power switch and then
turn it back on.
The remote control
does not work.
• Replace the batteries in the remote control.
• Make sure RoboVac is turned on and fully charged.
• If RoboVac and the remote control’s display work properly, but
RoboVac does not respond to the remote control’s commands,
it may be because the remote control has not been paired with
RoboVac.
In this case, do not dock RoboVac to the Charging Base. Turn off
the main power switch and then:
(1) press and hold on the remote control until the icon
blinks on the display;
(2) turn on the main power switch.
You will hear three beeps after successful pairing.
RoboVac stops
working suddenly.
• Check if RoboVac is trapped or stuck on an obstacle.
• Check if the battery level is too low.
• If you still have trouble, turn off the main power switch, wait for
2 seconds, and then turn it back on.
RoboVac does not start
scheduled cleaning.
• Make sure the main power switch on the side of RoboVac is
turned on.
• Make sure the time, time of day (AM/PM), and the scheduled
time have been set correctly.
• Check if RoboVac’s power is too low to start cleaning.
Clean the Sensors and Charging Pins
To maintain the best performance, clean the drop sensors and charging pins regularly.
• Dust off the drop sensors and charging contact pins using a cloth or cleaning brush.
Clean the Side Brushes
Foreign substances, such as hair, can easily get tangled in the side brushes and dirt may adhere to
them. Be sure to clean them regularly.
Carefully unwind and pull off any hair or string that is wrapped between the main unit
and the side brushes.
Use a cloth dampened with warm water to remove dust from the brushes or to gently
reshape them.
Only use the side brushes when they are completely dry.
Replace the Side Brushes
The side brushes may become bent or damaged after being used for a period of time.
Follow the instructions below to replace them.
Use a screwdriver to unscrew the screws on the side brushes.
