ETS SunQuest Pro 16ST, Руководство пользователя

Страница: 17 / 24

13
26487-02A
Replacing Lamps
Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approximate-
ly 800-1000 hours of use. Tanning will
continue after this time but at a slower
rate. Replace the lamp starters whenever
the lamps are replaced.
Removing/Replacing Acrylic Shield
and Canopy Grid
The acrylic shield in the bench and metal
grid in the canopy are secured in place by
hinged profiles which run the length of
the bed, both front and back.
Bench Shield
Simply pry up on the inside edge of the
profile until it releases its latching action
(see figure at right). Continue to pry up the
profile across its entire length until it
swings back freely. Repeat for the other
profile. The long edges of the acrylic
shield are now exposed. Standing in front
of the sunbed, grasp the long exposed
edge of the acrylic and carefully slide it
toward you until it is removed.
Canopy Grid
As you pry the hinged profile open the
canopy grid should start to drop out on its
own. You may want to have a helper hold
the grid while you pry open the profiles.
If you need to, slide the grid toward the
head or foot end of the sunbed and it will
drop out easily.
After changing the lamps, replace the
acrylic shield and canopy grid by revers-
ing the above directions. Close the hinged
profile by pushing it back into place until
it snaps tight.
PROFILE
CAUTION
Be careful. The edges of the acrylic shield
may be sharp.
Start pulling from the
middle of the profile!
WARNING
Shock hazard.
Disconnect power before servicing.
Care and Maintenance - Replacing Lamps