ETS-Lindgren 8100-040, Руководство пользователя, Страница: 31 / 44

www.ets-lindgren.com Operation
31
A
DMINISTRATION BY
LAN
Default IP Address of the Ethernet Interface is 192.168.1.253,
subnet mask 255.255.255.0
This IP address can be changed to any desired address according to your
network configuration. To be able to perform such change of the IP address,
a computer with matching IP settings has to be connected directly to the
amplifier.
To do this the LAN adapter settings of the control computer must be
temporarily changed.
Computer Configuration
Configure the control computer with:
IP address 192.168.1.xxx
where xxx is 001 or any number between 1 and 252
subnet mask
255.255.255.0
Check that the computer is connected to same Ethernet LAN than the
Ethernet interface of the amplifier.
Then call the amplifier’s settings page via the browser (see the following
screen shots), and change the amplifier’s IP settings to your desired network
configuration.
After that, you can set your computer’s LAN adapter settings back to the
original settings.
TCP/IP Configuration
IP address of each Ethernet interface must be unique on the network. An
individual address can be either assigned by:

A static address using administrative commands, or

An existing DHCP server on the network, who can assign an
available address.
If both DHCP and static IP address are defined, DHCP configuration will
override static IP.
Only one new Ethernet interface can be plugged on the LAN at a given time,
until an individual IP address is assigned on each Ethernet interface.
Otherwise conflicts will be caused.