ETOP SHB-E18, Руководство пользователя

Страница: 64 / 86

56 SHB-E18 User`s Manual
ECP Mode Use DMA
If your system supports ECP parallel port mode and you have the
port set to use ECP, you must use this setting to assign a DMA
channel for use by the port.
The choice: DMA1, DMA3
(default) .
If Parallel Port Mode Select is [ECP+EPP] will show:
Phoenix-Award BIOS CMOS Setup Utility
Super IO Device
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
UART Mode Select [IrDA]
RxD , TxD Active [Hi, Lo]
IR Transmission Delay [Enabled]
UR2 Duplex Mode [Half]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ ECP+EPP ]
EPP Mode Select [1.7]
ECP Mode Use DMA [3]
PWRON After PWR-Fail [Off]
Item Help
Menu Level
►
↑↓← → ：
Move Enter: Select +/-/PU/PD: Value F10:Save Esc: Exit
F1:General Help F5:Previous Value F6:Fail-Safe Defaults F7:Optimized Default
EPP Mode Select
Select EPP port type 1.7 or 1.9.
The choice: 1.7
(default) , 1.9.
ECP Mode Use DMA
If your system supports ECP parallel port mode and you have the
port set to use ECP, you must use this setting to assign a DMA
channel for use by the port.
The choice: DMA1, DMA3
(default) .
PWRON After PWR-Fail
When power fails, you can select power ON or Off or Former status.
The choice: Off
(default) , On, Former-Sts.