Eton Satellit 750, Руководство пользователя

Страница: 18 / 72

SATELLIT
OWNER’S MANUAL
18
To experience with SSB, turn on the Satellit and position near a
window if you are in a building with stories above you.
1. Turn on 20-meter Amateur band, by pressing 14150kHz with
the keypad and then pressing the AM button to enter it;
2. Quick press SYNC/SSB/RDS button twice to turn on SSB circuit,
i.e. don’t select SYNC. Note SSB appears in the display, then
displays “SSB-USB” or “SSB-LSB”;
3. Repeat quick press U/LSB/RDS MODE button to switch
between USB and LSB.
SSB-USB: upper sideband
SSB-LSB: lower sideband
4. SSB fine tuning: quick press down tuning knob to select tuning
speed as FAST/SLOW/FINE-XX(-99~+99)/STOP, then select
FINE –XX, which appears in the display to enter SSB fine tuning
mode. Rotate the tuning knob to set to it’s the best position.
Put the sensitivity switch, on the left side of the radio, to the
DX position. Fully extend the antenna and with the tuning knob
tune slowly from 14150 to 14350kHz, listening for anything
that sounds like a human voice.
5. Quick press SYNC/SSB/RDS button when finished to turn off
SSB to return to normal receiving status.
USING THE SYNCHRONOUS DETECTOR
The synchronous detector can be used when listening to AM and
shortwave broadcast stations. It may help to minimize interference
and to improve the signal qualitywhile listening to a station, turn
on the Satellit, select a AM or SW station, quick press SYNC/SSB/
RDS button to enter SYNC mode, ”SYNC>>>” appears in the display.
Then displays “SYNC_LSB” or “SYNC_USB”, the sync detector
function is on, repeat quick press U/LSB/RDS MODE button to
switch between USB and LSB. Quick press this button again to
turn off SYNC function and return to normal receiving.
Turn the synchronous detector off while tuning stations or
when it’s not needed. Using the Wide/Narrow button may also
help. Using the synchronous detector does not always minimize
interference or improve the signal.
Turn the synchronous detector off while tuning stations or
when it’s not needed. Using the Wide/Narrow button may also
help. Using the synchronous detector does not always minimize
interference or improve the signal.