Eton CXL-150 - SERVICE, Руководство по обслуживанию

Страница: 90 / 111

12.2 IGNITION COIL
Remove the spark plug cap from the spark plug.
Disconnect the ignition coil primary wire.
Measure the primary coil resistance.
STANDARD: 0.1 - 0.3
Ω
(20
℃
)
Measure the secondary coil resistance with
the spark plug cap in place.
STANDARD : 7.4 – 12 k
Ω
(20
℃
)
12.3 IGNITION TIMING
The ignition advance is 15
°±
3
°
/4000rpm
The Capacitive Discharge Ignition (CDI) system is factory pre-set and does not require adjustment.
12.4 ALTERNATOR EXCITER COIL
Remove the seat / rear fender and front fender. (See chapter 10)
Disconnect the exciter coil wire.
Measure the resistance between the yellow / red wire and ground.
STANDARD : 460-700
Ω
(AT 20
℃
, 68
℉
)
12.5 BATTERY INFORMATION
The battery gives off explosive gases; keep sparks, flames and cigarettes away. Provide adequate
ventilation when charging or using the battery in an open area. The battery contains sulfuric acid
(Electrolyte). Contact with skin or eyes may cause severe burns. Wear protective clothing and a face shield.
Electrolyte is poisonous. If swallowed drink large quantities of water or milk and call a physician.
BATTERY VOLTAGE INSPECTION
Battery is under the seat; you can see this battery
after removing the seat. Measure the battery voltage
using a voltmeter.
VOLTAGE: Fully charged: 13.1 V
Undercharged: Below 12.0 V
90