4
4.1
Iron Holder and Sponge
1)
Dampen the small cleaning sponge with water and then squeeze it dry. Place it in the groove of the
iron holder base
2)
Add a little water to the iron holder. The small sponge will absorb the water to keep the large
sponge above it wet all times. It may only use big sponge and not use small one
3)
Dampen the larger cleaning sponge and place it on the iron holder base
Note: If the sponge becomes dry during working, add appropriate water.
4.2
Connection
CAUTION: Be sure to turn off the power switch before connecting or disconnecting the soldering
iron. Failure to do so may damage the soldering station.
1)
Connect the connector plug of the iron handle cord to the socket in front of the soldering station.
Take notice of the inserting position of connector plug
2)
Place the soldering iron in the iron holder
3)
Insert the power plug into the grounding power socket
4)
Connect one end of grounding cord to the grounding hole of the soldering station and the other to
ground
5)
Switch on the power supply
4.3
Setting the parameters
4.3.1
Setting the password
The initial password is 000 and the temperature can be set after turning on the power supply at this state.
If administrator wants to limit the authority and he can change the password and then those being
authorized can set the parameters.
1.
Enter the password setting:
Turn off the power supply. press and hold
“
△
”
and
“
▽
”
keys simultaneously and then press the power
switch until the display shows
.It means in the password setting state.
2.
Enter the initial password:
Press
“*”
key after the display shows
, and then the display shows
. In the
state, input the initial password by pressing
“
△
”
and
“
▽
”
keys. And press
“*”
key after inputting the
right password.
a) If the inputted password is error:
The soldering station will jump over the password setting process into the normal working
process after the display shows the setting password about four seconds. But the
temperature cannot be changed in normal working process because of inputting the error
password.
