11
5.5
Error messages
Various error messages will be displayed when there is something wrong with the device. If the following
message is displayed, refer to the 5.6.
Sensor error:
if there is some malfunction in the sensor or anywhere in the sensor
circuit, “
S-E
” will be displayed and the power supply to the soldering iron will be cut
off.
Heater error:
If there is something wrong with the heating element, “
H-E”
will be
displayed and the power supply to the soldering iron will be cut off.
5.6
Check and replace the soldering iron
When there is something wrong with soldering iron, you can check and test it. If it is broken, replace the
broken element.
5.6.1
Check the soldering iron
1)
Turn the power switch off and disconnect the power plug
2)
Disconnect the handle connector from the station, and disassemble it after it cooling down
3)
Don’t use metal tools such as pliers to remove the tip or the tip enclosure from the handle
instead of using heat resistant pad
4)
Screw down the sheath at the end of the handle
5)
Pull the heating element out from the handle towards the handle cord
S
–
E
H - E
