ETNA VWT349WIT, Инструкция по эксплуатации

Страница: 47 / 56

EN 21
Symptom Possible cause Solution
Contamination of the tub. Poor quality detergent. Only use detergent suitable
for dishwashers to prevent
contamination.
Blocked filters. Open the door and clean
the filters. Run the pre-wash
cycle.
Rinse agent has been spilled. Always wipe up spilled rinse
agent immediately.
Dishes not dry. The rinse agent reservoir is
empty.
Ensure that the rinse agent
reservoir is filled.
Dishes and flat objects are
not clean.
Incorrect cycle. Select a higher cycle.
Basket is incorrectly loaded. Make sure that the detergent
compartment and spray arm
are not obstructed by large
dishes/pans.
Spotting and scaling on
glasses and flat dishes.
Extremely hard water. To remove spotting from
glass objects: remove
all metal objects from
the dishwasher. Use the
prescribed quantity of
detergent. Select the longest
cycle. Allow the dishwasher
to run for approximately
18 to 22 minutes. It should by
then have reached the main
wash cycle. Open the door
carefully and pour 2 cups of
white vinegar into the base.
Close the door and allow the
dishwasher to complete its
cycle.
If vinegar does not work:
repeat the above steps, but
use a quarter cup (60 ml) of
citric acid crystals in place of
white vinegar.
Incoming water temperature
is low.
The dishwasher is
overloaded.
Basket is incorrectly loaded.
Old or damp detergent.
Rinse agent reservoir is
empty.
Incorrect detergent dosage.
Cloudy stains on the
glassware.
Combination of soft water
and too much detergent.
Use less detergent and
choose the glass cycle,
which you can use to clean
glassware.
Yellow or brown scale on the
inside of the tub.
Traces of iron in the water
may cause spotting to the tub
of the dishwasher.
Contact a manufacturer of
water softeners for a special
filter.
White scale on the inside of
the tub.
Hard water. Increase salt consumption
setting.
TROUBLESHOOTING