ETNA VWT349WIT, Инструкция по эксплуатации

Страница: 34 / 56

EN 8
Stopping or changing a wash cycle
1. Open the door.
2. Press the start/reset button more than three seconds.
3. Select the desired washing program with the selector button.
4. Close the door.
5. Switch on the appliance with the start/reset button.
Attention!
A cycle that has already begun can only be changed in the start-up
phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
Warning!
It is dangerous to open the door completely when washing, because the hot
water may scald you.
At the end of the wash cycle
Once the wash cycle has completed, an audible signal will sound for
eight seconds.
1. Switch the appliance off using the On/Off button.
2. Open the door.
3. Wait a few minutes before unloading the dishwasher. The dishes
and cutlery will still be very hot immediately following the end of the
cycle. There is a chance that dishes may break as a result of the
heat. Moreover, the dishes dry better when allowed to stand for a
few minutes.
OPERATION