Installation manual (v. 2/2017)
Vehicle unit ETLOC-50 ONLINE
9
Note:
In case the vehicle is equipped with a metallized windshield (a heated windshield is not a problem for
GPS signal reception) it is necessary to place the GPS antenna, for example, into the side mirror, front
plastic bumper or other location where its view to the sky will not be obstructed.
4. Activation of the vehicle unit
a) Attach a GPS antenna's SMB connector and
wiring harness connector to the vehicle unit
(
after attaching of the cable harness the
vehicle unit does not activate yet - it is still
turned off
).
b)
Start the vehicle
and wait for approx. 2 minutes
(during this time the unit initializes). LEDs on the
vehicle unit indicates its current state.
c) From your mobile phone send a SMS with
command
state
to a telephone number of the
vehicle unit (written on an information label). You
will receive a SMS reply with information about
the installed vehicle unit's current state.
1. IMEI
– a unique identification number of a vehicle unit
2. Inputs state
IGNITION / BUSINESS JOURNEY / Input 3 / Input 4
3. Switching relay state
4. STOP function state
Function STOP activation / Execution of STOP output
5. Car battery voltage
6. Backup battery voltage
7. Charging of the backup battery
8. GSM signal power
9. GPRS state
Period of data sending / Data network connection
10. GPS module state
Module turned ON / Current position / Number of visible satellites
Note: 0
– no/off, 1 – yes/on
d)
Turn off the vehicle’s ignition and resend the SMS with
state
command. In received SMS
check if the input IGNITION is not active (INPUTS
0
/0/0/0).
After
turning the vehicle’s ignition off wait approx. 5 minutes
and check if the vehicle unit
is still being powered (red LED must be blinking). With this procedure you will verify that the
circuit, chosen for supplying power to the vehicle unit, is not time-restricted and does not cause
a shutdown of the vehicle unit
–
perform this test with disconnected backup battery
.
LED is blinking 1 x
per second
The unit is connecting to GSM
network
LED is blinking 1 x
per 3 seconds
The unit is connected to GSM
network
LED is blinknig 3 x
per second
The device is connected to
GSM and GPRS
LED is not blinking
The unit is switched off
LED is blinking 1 x
per second
The unit is trying to receive
GPS data
LED is blinking 1 x
per 3 seconds
The unit is receiving actual
GPS data
LED is not blinking
GPS module is switched off
Green LED – indicates GPS status
Red LED – indicates GSM status
IMPORTANT
STATE:
IMEI 866104028872547
INPUTS 1/0/0/0
SWITCH 0
STOP 1/0
CBAT 12,6V
BBAT 6,4V
CHARGE 0
GSM 28
GPRS I60s/1
GPS 1/1/5
state
