ETI 51402241, Инструкция по использованию и уходу

Страница: 9 / 12

9 ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
Pir Sensor Testing (continued)
4
1. Auto Mode Set-up
□
Once the fixture has been tested for proper operation
and sensitivity, rotate the TIMER control knob past
the “TEST” setting into the timer settings. The timer
settings indicate how long the light stays on after the
PIR senses motion.
2. Auto Mode Operating
□
Rotate the TIMER control knob past the “TEST” setting
into the timer settings. The timer settings indicate how
long the light stays on after the PIR senses motion.
Rotating this knob clockwise raises the stay on time of
the motion sensor for up to 5minutes .Rotating the knob
counterclockwise shorten the stay on time to as close as
10seconds (can’t past test position). It may be necessary
to adjust the TIMER knob several times until the desired
ON time is achieved.
5
Manual Override Mode (8-hours auto Rest)
□
To shift to the manual override mode, set the VR knob to “AUTO” mode. Turn the wall switch “OFF” and
then turn it “ON” within 2 seconds.
□
To shift back to the “AUTO” mode, turn the wall switch “OFF” and then turn it “ON” within 2 seconds
again.
□ The light will turn off automatically at dawn.
There is LED
indicator inside