Etherma eTOUCH-PRO-WB, Инструкция по установке и использованию

Страница: 32 / 82

32
I N S T A L L A T I O N , S T A R T U P
Wires must be stripped 9-10 mm. Wires can be released by pressing the
connector’s release switch. Floor sensor must be placed into protective
tube in concrete. Make sure there is no water in the tube.
Next, position the thermostat and fasten it onto the wall’s mounting box
using 2-4 screws. Open the frame retaining spring, position the frame
and close the spring. Then attach front part, make sure the connector
between front and bottom part is correctly placed. Press front part until
it snaps in place. Front part can be later removed by pressing the ejector
latch.
STARTUP
After connecting the power to the thermostat for the first time or after
performing a factory reset startup wizard will prompt the following ques-
tions: