ETEKCITY MSR-A600, Руководство пользователя

Страница: 10 / 28

10
ii. AC or DC Measurement
1. Insert the
black test lead
into the
COM
terminal, and the
red test lead
into the
terminal.
2. Turn the rotary dial to .
Note:
The default function is DC. Press
SEL/REL
to switch between AC and DC
measurement.
3. Connect the test leads to the object
being measured. Hold them in place until
the readings on the display stabilize.
4. When the measurement is complete,
disconnect the test leads from the
object, then remove the test leads from
the multimeter.
Note:
In each range, the multimeter has
an input impedance of 10M
Ω
. This loading
effect can cause measurement errors
in high impedance circuits. If the circuit
impedance is less than or equal to 10M
Ω
,
the error is negligible (0.1% or less).
Voltage Measurement
Operation
WARNING
DO NOT measure voltages higher than
600V. Doing so may result in electric
shock, damage to the multimeter, or
injury to the user. Always take extra
care to avoid electric shock when
measuring high voltages.
i. AC or DC Voltage
1. Insert the black test lead into the COM
terminal, and the red test lead into the
terminal.
2. Turn the rotary dial to or .
3. Connect the test leads to the object
being measured. Hold them in place until
the readings on the display stabilize.
4. When the measurement is complete,
disconnect the test leads from the
object, then remove the test leads from
the multimeter.