Etco IP-Mini, Инструкция по эксплуатации

Страница: 29 / 29

ETCO Incorporated, Tel: 401-467-2400 Fax: 401-467-9230 Web: www.etco.com
USE ONLY ETCO TOOLING
SECTION 4
DESCRIPTION
ETCO IP MINI REAR FEED APPLICATOR – page 6
A
HEIGHT ADJUSTING DIAL/WIRE
ROLLING TOOL ONLY:
Set at appropriate letter pad setting.
Number and letter pad settings
located on Assembly Drawing in
pocket on inside back cover of this
manual.
B
HEIGHT ADJUSTING DIAL/
INSULATION ROLLING TOOL ONLY:
Set at appropriate number pad setting.
C
BRAKE CAM:
Rotate 90 degrees to brake in relief posi-
tion.
D
FEED FINGER ARM ROUGH ADJUST:
Used to adjust approximate feeding
distance. Loosen locking screw on feed
finger to change position of finger.
Tighten locking screw.
E
BRAKE TENSION ADJUSTMENT:
Tighten knob clockwise to increase
brake tension, counter-clockwise to
decrease tension. Optimum position is
to have screw bottomed out.
F-G
FEED ADJUSTING SCREW/
LOCKING SCREW:
To adjust final feeding distance, loosen
locking screw
G
. Turning screw
F
clockwise increases feeding distance,
counter-clockwise decreases feeding
distance. Tighten locking screw
G
when
adjustment is complete.
H
SAFETY PIVOT PIN:
If replacement is needed for safety pivot
pin, use spare pins on top of frame.
I
CRIMP TOOL HOLDING SCREW:
When replacing crimp tools, note that
all tools, spacers and washers are in
position before operating.
F
E
C
H G
D
I
A
B
4