The display panel on the rear of the
AR 250
allows for the electronic alignment of the projector’s motors. This procedure is perfor-
med the factory. It may be useful to perform this procedure in the case of internal components being replaced.
Altering the factory settings may radically alter the functioning of the projector. Carefully read all of the following prior to
attempting any changes.
electronic calibration
Important Note:
This procedure can only be undertaken if the projector is correctly receiving DMX 512 signal.
Important Note
:
At the termination of the above electronic calibration procedure, if the END function is not performed, no
memory changes will be effected. This allows the operator to abort any changes made, in case of operator error.
A 0 0 1
DIMM
dimmer
dimmer calibration
C Y A N
cyan
cyan movement motor calibration
MAG
magenta
magenta movement motor
calibration
YELL
yellow
yellow movemnt motor calibration
E N D
end
to end the calibration procedure
☞
enter
0 1 2 8
☞
enter
es.
0 1 2 0
☞
enter
0 1 2 8
☞
enter
es.
0 1 4 0
☞
enter
0 1 2 8
☞
enter
es.
0 1 2 0
☞
enter
0 1 2 8
☞
enter
es.
0 1 2 0
☞
+
☞
menu
☞
enter
together during reset
NOTE:
to speed up the alignment/calibration procedure it is possible to press the
+
and
-
keys at the same time to make the display
jump directly to 128
☞
+
☞
-
0 1 2 8
at the same time
☞
+
☞
+
☞
+
☞
+
o
–
☞
+
o
–
☞
+
o
–
☞
+
o
–
R E S E
reset
all motors reset
AOO1
☞
+
☞
menu
FUNC
MODE
☞
enter
☞
+
PDIR
☞
enter
Attention
This section is reserved for technicians and persons with technical experience only.
23. Electronic motor alignment
29
English
Содержание Irideon AR250
Страница 1: ...instructions manual ...
