Set Up and Focus the Fixture
7
Set Up and Focus the Fixture
WARNING:
Note the following safety warnings before use:
•
Only use mounting hardware that is rated for the total weight of the
fixture and accessories.
•
In addition to primary suspension, attach a safety cable (or other
approved safety device) to the fixture. Safety cables must be rated to
support ten times the fixture weight. Consult local standards to ensure
that safety cables meet all requirements. See
.
•
Check that the accessory holder is locked and that any accessory safety
cables are connected before mounting the fixture.
AVERTISSEMENT :
Prendre connaissance des avertissements de sécurité
suivants avant toute utilisation :
•
N’utilisez que de la quincaillerie de montage adaptée au poids total
des projecteurs et des accessoires.
•
En plus de la suspension principale, fixez une chaîne de sécurité (ou
tout autre dispositif de sécurité homologué) au projecteur. Les chaînes
de sécurité doivent être en mesure de supporter dix fois le poids du
projecteur. Consultez les normes locales pour vous assurer que les
câbles de sécurité respectent toutes les exigences.
•
Vérifiez que le porte-accessoires est verrouillé et que les élingues de
tous les accessoires sont bien attachées avant de monter le projecteur.
B
A
Mount the Fixture
You can mount the fixture using a clamp, baby-pin (16 mm) receiver,
or spigot on the yoke (A), or you can set the fixture on the floor or
another flat surface. When suspending the fixture, make sure to
secure the fixture with an appropriate safety cable at the safety cable
attachment point (B).
If necessary, move the adjustable yoke (D in image below) to balance
the fixture. Use a 13 mm socket wrench to loosen the bolt and shift the
yoke position, and then tighten the bolt to secure the yoke.
D
C
C
Add Accessories
You can use up to two standard accessories (one scrim
and one additional accessory, such as a barn door) in the
accessory holder.
1.
Unlock the accessory holder on either side by
pressing the spring-release and rotating the
accessory holder lock (C).
2.
Slide an accessory into one of the accessory slots.
Add a second accessory in the other slot, if needed.
3.
Lock the accessory holder by rotating the accessory
holder lock back into place.
4.
If necessary, move the adjustable yoke (D) to
balance the fixture when using heavier accessories.
