Page 7
ELED2(H) Installation Guide
Tunable White Dimming Controller
Power
LED
Clear
Button
Learn
Button
Learn
LED
LED Driver
Battery Backup
Normal Hot
Normal Neutral
ELED2 Load Control
Dim +
LED +
LED -
LED +
LED -
LED
Emmitter
Dim -
Neutral
Analog color
control
Wiring Diagrams - For use in Emergency Fixtures
(2 of 2)
LED Blink Codes and Operation
The tables below describe the LED activity and associated mode of the
controller.
If the controller was factory pre-commissioned, upon power up it will
immediately begin blinking the POWER LED based on the type and count of
linked devices.
Channel 1 links are displayed with red LED blinks.
Channel 2 links are displayed with green LED blinks.
Channel 3 links are displayed with blue LED blinks.
The type is indicated by long blinks followed by short blinks counting the
number of devices linked. This pattern will repeat after a short pause.
See the ELED2 programming guide for more information:
https://www.echoflexsolutions.com/files/8DC-5884-ELED2-Programming-Guide.pdf
The table below describes the number of LED blinks for each device type
.
Dimming - Channel 1 - RED POWER LED Blink Codes
Factory Default
ON Solid
switch(es)
1 long blink
followed by short blinks counting switches
occupancy sensor(s)
2 long blinks
followed by short blinks counting sensors
photo sensor(s)
3 long blinks
followed by short blinks counting sensor
(typical max 1)
central command
4 long blinks
followed by short blinks counting devices
demand response
5 long blinks
followed by short blinks counting devices
Tunable White - Channel 2 - GREEN POWER LED Blink Codes
Factory Default
OFF
switch(es)
1 long blink
followed by short blinks counting switches
CCT sensor linked
2 long blinks
followed by short blinks counting sensors
(typical max 1)
Central Command
3 long blinks
followed by short blinks counting sensor
