Page 6
ELED2(H) Installation Guide
If linking a sensor, press the sensor’s TEACH or LINK button, refer to
the sensor’s documentation. The POWER LED will remain lit for four
seconds while it links the new device. It will resume toggling allowing
you to link another device up to a total of twenty devices.
3. To exit link mode, press and release the LEARN button on the controller.
i
Note:
Linking a switch or sensor that is already linked to a
channel, will remove or unlink it from the channel.
i
Note:
Link mode will time out after no activity in thirty
seconds.
CLEAR button
Using the CLEAR button can reload the controller to the factory pre-
commissioned settings with linked devices OR it can load the factory default
parameters and remove all linked devices.
• To return the controller to the factory pre-commissioned state, press
the CLEAR button until the red POWER and green LEARN LEDs start
blinking, approximately 5 seconds. Release the button and the red
POWER LED will begin blinking indicating the factory commissioned
pre-linked devices.
• To completely clear the controller returning it to factory default
settings removing all linked devices, press the CLEAR button until the
red POWER and green LEARN LEDs come on solid, about 15 seconds,
then release. The POWER LED will stay ON solid indicating the factory
default state.
Tunable White Dimming Controller
Power
LED
Clear
Button
Learn
Button
Learn
LED
Normal Hot
LED Driver
Normal Neutral
Emergency Hot
Emergency Neutral
Normal Control Sense
Normal Emergency
Load
LED Driver Neutral
LED
Driver
Hot
Dimming
+
Wiring Diagrams - For use in Emergency Fixtures
(1 of 2)
Dimming -
0-10V analog color control
UL924 Emergency
Bypass Relay
with appropriate
voltage rating
