Echoflex Installation Guide
Preset Station
2.
Set the Address rotary switch to the desired address (1 through 16) for
the station identification in the assigned Space.
CAUTION:
Each device on the bus must have its address set to a
unique number (1 through 16) for the space it controls. If two or more
devices use the same address for the same space, the system will not
function properly.
DIP Switch Settings
Functionality is set using DIP switches located just beneath the rotary
switches. The label on the rear of the station identifies these components and
functions.
Switch #
Use
1
Use Off - When this is set to Off, the “Off” function of the station is
not provided.
2
Custom Config - When set to On, custom configuration settings are
applied using ElahoAccess. The default position is Off.
3
Disable IR Input - When On, the infrared input will be disabled.
4
Fade Time Disable - Applies a 0 second fade time to all station
actions for non-dim switched mode behavior (when dimming
features are not wanted).
5
Future development
6
Future development
7
Future development
8
Restore to Defaults at Boot - Setting this DIP switch On, then cycling
power to the station restores the station to factory defaults. Reset
the switch Off after power cycle.
Elaho Preset Station
Page 3 of 8
Echoflex Solutions, Inc.
