ETC E-DVAC-C-LR, Руководство по установке

Страница: 7 / 12

ETC Installation Guide
Dual Tech Vacancy Sensor
DIP Switches
DIP switches on the sensor electronics provide for additional configuration
options including Use Custom Config, Vacancy Timeout, Enable/Disable
detection LEDs, PIR Only Mode, and the ability to restore the sensor to its
factory defaults.
Switch # Use
1 Unused (leave Off)
2 Enable/Disable Custom Config Mode
•
When “Custom Config” is set to Off (default), also known
as Basic configuration mode, the local DIP switch settings
for Vacancy Timeout, Enable PIR LED, and dual technology
features are used. See
Configuration on page 8
.
•
When “Custom Config” is set to On, all other local DIP
switch settings are ignored. Instead, the settings made by
the EchoAccess App are used.
3 and 4 Vacancy Timeout
•
5 min = Switches 3 and 4 are Off
•
15 min = Switch 3 is Off and Switch 4 is On (default)
•
30 min = Switch 3 is On and Switch 4 is Off
•
Auto = Both switches are On
5 Detection LEDs
•
When set to On (default), the occupancy detection LEDs
illuminate when movement is detected.
•
When set to Off, the occupancy detection LEDs are
disabled unless the unit is in Walk Test mode.
6 PIR Only Mode
•
When set to On, acoustic detection technology is disabled
for the sensor.
•
When set to Off (default), both PIR and acoustic detection
technologies are used by the sensor.
7 Unused (leave Off)
8
Restore to Defaults at boot
•
When set to On and power is cycled to the sensor, the
unit restores to its factory default settings.
•
Off is the default setting.
Dual Tech Vacancy Sensor Page 7 of 12 ETC