ETC ColorSource Fresnel V, Руководство по установке

Страница: 4 / 16

ETC Installation Guide
ColorSource Fresnel V v1.1
Power Up
Press any button to wake the display. The display shows the DMX
address. See
Set the DMX Address on the facing page .
You can press the Mode button to access the Presets/Sequences menu.
See
Play Presets and Sequences on page 10 .
You can press the Zoom encoder to enter Focus mode and adjust the
zoom. See
Adjust the Zoom and Focus the Fixture below .
Adjust the Tilt
The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knob.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knob.
Adjust the Zoom and Focus the Fixture
DOWN
UP MODE
DMX IN
POWER THRU
POWER IN
ZOOM /
ZOOM /
Yoke
locking
knob
Zoom encoder
• Turn to adjust zoom
• Press to enter Focus
mode
1. Press the Zoom encoder
to enter Focus mode. All
LEDs turn on at full, and
the display shows
Foc
.
2. Turn the Zoom encoder
to adjust the zoom
between flood and spot.
Turn the encoder
clockwise to adjust
toward flood, or
counterclockwise to
adjust toward spot.
3. Press the Zoom encoder
again to exit Focus
mode. (Focus mode will
end automatically after
5 minutes if you do not
exit the mode.)
Accessories
You can insert two 7.5 in accessories in the accessory slot. For available
accessories, see the ColorSource Fresnel V datasheet at
etcconnect.com .
You can attach a ColorSource Relay to the yoke. See etcconnect.com for
more information about ColorSource Relay.
ColorSource Fresnel V Page 4 of 16 ETC