ETC Installation Guide
D1 & D2 Series Drivers
D1 & D2 Series Drivers
Page 24 of 25
ETC
WARNING:
RISK OF ELECTRIC SHOCK! The light sources in this luminaire are
not user-replaceable, and must be replaced only by a qualified technician.
Contact ETC Customer Support for assistance.
AVERTISSEMENT :
RISQUE DE DÉCHARGE ÉLÉCTRIQUE! Les sources
lumineuses de ce projecteur ne sont pas remplaçables par l'utilisateur et
doivent être remplacées seulement par un technicien qualifié. Contactez le
service client ETC pour obtenir de l’assistance.
WARNING:
Disconnect the fixture from power and DMX and allow it to cool
before performing any cleaning and maintenance.
AVERTISSEMENT :
Débrancher la lampe de son alimentation et du DMX et
la laisser refroidir avant d’effectuer un nettoyage ou un entretien.
CAUTION:
Check for excessive dust or debris in the heat-dissipating fins around
the entire luminaire enclosure. Clean using compressed air or a soft cloth.
Keeping the components of the enclosure clean facilitates efficient cooling and
extends LED longevity.
NEVER spray liquids into the luminaire.
NEVER spray compressed air into a luminaire that is powered-up.
A can of compressed air or oil-free air from an air compressor set at a low setting can be used to
blow through the vent holes and remove dust or other debris. Dust buildup can cause overheating
and premature shutdown.
All components can be cleaned using compressed, oil-free air as described above or a clean micro-
fiber cloth. The use of any liquid cleaning solution is not recommended.
Inspect all mounting hardware for wear and, if necessary, clean using compressed, oil-free air or a
soft, lint-free cloth.
Emergency Operation and Test
It is important to test ArcSystem emergency systems regularly because they are life safety devices.
NOT SELF-TESTING PER ANSI/NFPA 101 - This equipment is not self-testing in conformance with
the Life Safety Code, ANSI/NFPA 101. ANSI/NFPA 101 Life Safety Code requires testing of life
safety devices every 30 days.
To test the emergency functionality of this device, disconnect the sense circuit.
WARNING:
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
power to the system before installation, maintenance, cleaning, or any other
system modification could result in serious injury or death.
AVERTISSEMENT :
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE! Négliger
de débrancher toutes les sources d’alimentation du système avant l’installation,
l’entretien, le nettoyage ou toute autre modification du système peut causer
des blessures graves ou la mort.
De-energize main feed to ArcSystem and follow appropriate Lockout/Tagout
procedures as mandated by NFPA 70E. It is important to note that electrical
equipment such as breaker panels can present an arc flash hazard if improperly
serviced. This is due to the high amounts of short-circuit current available on
the electrical supply to this equipment. Any work must comply with OSHA Safe
Working Practices.
