Wall-Mount Driver Installation
17
Wall-Mount the Driver
1. Using a Phillips screwdriver, remove the two screws securing the cover to the ArcLamp
Driver enclosure. Set screws aside for later re-installation. The cover is grounded by a
tether to the enclosure.
•
ArcLamp Driver 350 and 700 wall-mount drivers have two hooks inside the cover and
slots on the bottom side of the enclosure so that you can hang the cover during
installation.
2. Align the ArcLamp Driver in its desired installation location and mark, then pre-drill the
four mounting holes.
Note:
Vents on back of driver must not make contact with the wall for proper airflow.
3. Install wall anchors as needed.
4. Align the driver to the mounting location and install the mounting hardware. Secure the
hardware.
5. Install conduit hardware as required for your installation wire plan.
•
ArcLamp Driver 150 wall-mount drivers: Remove the knockouts required based on
your installation wire plan and install conduit hardware accordingly.
•
ArcLamp Driver 350 and 700 wall-mount drivers:
•
Using a Phillips screwdriver, remove the five screws securing the removable panel
on the left side of the enclosure.
•
Punch holes as needed for conduit for power connection and data connection.
•
Reinstall the removable panel to the backbox.
Note:
Make sure that the flexible electrical supply can extend through the ceiling
opening so that the driver and luminaire can be inspected and serviced when needed.
Note:
Use suitable conduit where required by national and local codes.
Note:
Drivers may require additional means of securement. Installation must follow
all national and local codes for electrical equipment.
Terminate Wiring
WARNING:
RISK OF DEATH BY ELECTRIC SHOCK! Before you begin pulling
and terminating wire to the ArcLamp Driver enclosure, make sure the main
circuit breaker cabinet or other readily accessible input power disconnect
device for the normal power input (and emergency power input when used)
is locked out and tagged out.
AVERTISSEMENT :
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE! Avant
de passer le câblage et de le raccorder au boîtier du driver ArcLamp,
s’assurer de la coupure électrique du disjoncteur principal ou d'une autre
arrivée électrique pour l’alimentation normale (et l’alimentation de secours
lorsqu’elle est utilisée); s’assurer aussi que le disjoncteur ou le dispositif de
déconnexion est verrouillé et identifié.
Diagrams and instructions for ArcLamp Emergency System drivers are located in
Driver Power Input Wiring on page 46
.
