ETAS ES5340.2, Руководство пользователя

Страница: 31 / 120

ES5340.2 Electric Drive Simulation Board -User’s Guide 31
ETAS Hardware Description
3 Hardware Description
This chapter provides a description of the inputs and outputs of the ES5340.2
Electric Drive Simulation Board along with the signals that it can measure and
those that can be generated for it.
Specifically, it includes information about the following topics:
• "Generating Analog Signals" on page 32
These outputs are used for different analog signals via an output multi-
plexer.
– "Specification" on page 32
– "Configuring the Analog Signals" on page 33
• "Output Multiplexers for the Analog Signals" on page 36
Each analog output has a multiplexer that can be used to define the signal
for this output.
• "Generating Digital Signals" on page 38
These outputs are used for different digital signals via an output multi-
plexer.
– "Specification" on page 38
– "Configuring the Digital Signals" on page 40
• "Output Multiplexers for the Digital Signals" on page 41
Each digital output has a multiplexer that can be used to define the signal
for this output.
• "Analog Inputs" on page 42
The ES5340.2-M has four inputs for measuring analog signals.
– "Specification" on page 42
– "Configuring the Analog Inputs" on page 42
• "Digital Inputs" on page 42
The ES5340.2-M has 20 inputs for measuring digital signals.
– "Specification" on page 42
– "Configuring the Digital Inputs" on page 43
• "RPM Generator" on page 47
The ES5340.2 Electric Drive Simulation Board has a central RPM Generator
that outputs a speed-specific clock signal.
– "Angle Clock Signal" on page 47
– "Synchronization" on page 48
– ""Master with Angle Adaptation" RPM Mode" on page 48
Note
The step-by-step execution of the configuration is in the chapter "Configuring
the Hardware in LABCAR-RTC" on page 65.