29
GB
TROUBLESHOOTING
If there are problems with operation, immediately turn off the
machine and unplug it from the socket-outlet.
The coffee maker does not supply boiling water for tisanes.
1 Air has probably entered the circuit and deactivated the pump.
• Make sure the tank is properly inserted and that the water is not below the minimum
level. Repeat the operations described in the “Preliminary phases for use” paragraph.
2 The steam exit hole on the dispenser wand is clogged.
• Unclog any deposits that may have formed in the hole of the dispenser wand with a
pin.
The coffee maker does not supply steam.
1 There is little water and the pump does not suck it up.
• Check that the water level in the tank is correct. If necessary, fill it with cool tap water.
2 The steam exit hole on the dispenser wand is clogged.
• Unclog any deposits that may have formed in the hole of the dispenser wand with
a pin.
Coffee overflowing from the edges of the filter ring.
1 Probably an excess amount of ground coffee has been placed in the filter ring preventing
the filter ring from being correctly tightened into its housing.
• Slowly remove and disconnect the filter holder because any remaining pressure could
cause splashes or squirts. Clean the coupling seat with a sponge (Fig. 12). Repeat the
operation placing the correct quantity of coffee in the filter.
2 Residues of ground coffee have remained on the gasket of the filter holder coupling
seat.
• Slowly remove and disconnect the filter holder because any remaining pressure could
cause splashes or squirts. Clean the seal with a toothpick or a sponge (Fig. 12).
3 The hole of the silicone disc is clogged.
• Wash the silicone disc (D) under running water, bending it slightly on the sides in order
to free the centre hole of any residue of coffee grounds that could clog it (Fig. 11).
4 The exit holes of the filter containing coffee grounds are clogged.
• Clean the clogged filter holes with a small brush or a pin. Clean the filter using ETA
UNIACTIV product, following the instructions provided in the package.
The coffee is not supplied or flows too slowly.
1 The holes of the perforated disc in the filter holder coupling seat are clogged.
• Turn on the machine without the filter holder, making the water run. If the water still does
not come out from all the holes evenly, carry out the descaling cleaning operation using
the UNIACTIV product found at ETA service centres, following the instructions provided
in the package.
2 The exit holes of the filter containing coffee grounds are clogged.
• Clean the clogged filter holes with a small brush or a pin. Clean the filter using ETA
UNIACTIV product, following the instructions provided in the package.
3 The coffee blend is ground too fine.
• Try using coarser coffee blends.
4 The coffee blend is pressed down too much.
• Tamper coffee inside the filter using less pressure. 5 The tanks is not inserted well.
• Fit the tank securely by pushing it as far as it will go. 6 The hole of the silicone disc is
clogged.
ETA IM - ETA 3175_Elisir cafe 1329 29
ETA IM - ETA 3175_Elisir cafe 1329 29
23.12.2008 18:44:04
23.12.2008 18:44:04
