eta ORBITO 1509, Инструкция по эксплуатации, Страница: 22 / 48

– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin in
the direction of the arrow and pull out or push in the required length of the tube. When you
release the lock projection, the tube length is fixed. When pulling out, keep the tube in safe
distance from your face as the tube is very long.
Floor nozzle (Fig. 2)
– Connect and disconnect the accessories ( C1 ) in the same way as the tube.
Floor / crevice nozzle / brush (Fig. 3)
– Connect and disconnect the accessories ( C4 , C5 , C6 ) in the same way as the tube.
You can connect the appliance directly to the hose handle or to the telescopic tube.
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A5 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories C1 , C2 , C3 (Fig. 2, 3, 4). If the cleaner is fitted with telescopic
tube C3 , adjust its length to fit your figure (Fig. 3). Floor nozzle C1 is designed to be used
to clean carpets or smooth flooring (Fig. 5). If the floor nozzle is fitted with a brush, pull it
out by switching over a flap when vacuuming hard floorings. You can use crevice nozzle
C6 for vacuuming places that are hard to access (Fig. 6). Upholstery nozzle C4 or brush
C5 can be used to clean various types of furniture (Fig. 7, 8). The vacuum cleaner can be
switched on or off by pushing button A4 marked with the symbol (Fig. 9). The suction
power can be adjusted with the control on hose handle C2 (Fig. 10). The minimum suction
power is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power
is recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, switch off
the vacuum cleaner and unplug it from the power supply. By switching button A3 with symbol
(Fig. 9) the power cord will be wound automatically. The vacuum cleaner can
be held and carried by handle A7 , or B1 .
Emptying the dust container
When vacuuming, watch the level of filling of the container with dust. When you notice the
container is full up to the MAX mark or you feel significant decrease in the suction power,
empty the container. Press container lock buttons A6 and then remove container B from the
vacuum cleaner (Fig. 12A). Put the container above a dust bit and press button B2 ; thus you
will lift off bottom B3 and throw the dust in common municipal waste (Fig. 11). Snap the bottom
shut to secure it and insert the container into the vacuum cleaner in the opposite direction. For
sanitary reasons we recommend emptying the container outside housing premises.
Cleaning the dust container and microfilters
After approx. 5 emptying of the container we recommend carrying out a complete cleaning
of the filtration system from settled dust. Do this following these steps:
– Press the container arrest button A6 and pull the container B out of the vacuum cleaner
(pic. 12A).
– Grab the body of the container B with one hand and turn the container lid B5 counter -
clockwise (in the direction of the opened lock) with moderate strength, see pic. 12B.
– Remove the textile microfilter B4 from the top part B6 of the separator. Put the filter back
with its protruding edge facing the inside of the container.
22
GB
/ 39