eta 0762, Инструкция по эксплуатации

Страница: 15 / 32

– Use the appliance in the working position only at places with no risk of turning over
and in sufficient distance from heat sources (e.g.
heater, stove, cooker, oven, grill
),
flammable objects (e.g. curtains, drapes, etc. ) and wet surfaces (e.g. sinks, wash
basins, etc.
).
POWER CORD:
–
If the power cord of the appliance is corrupted, it has to be
replaced by the manufacturer, its service technician or a similarly
qualified person so as to prevent dangerous situations.
– Never put the power cord on hot surfaces and never let it hang over table edge or
worktop edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn
and fall down, causing a serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– If you need to use an extension cord for justified reasons, it must be undamaged and
comply with the applicable standards.
– Check the condition of the power cord of the appliance regularly.
– In order to ensure safety and proper function of the appliance, use only original spare
parts and accessories approved by the manufacturer.
– Only use this appliance for the purpose it was designed for, as specified in this manual.
Never use the appliance for any other purpose.
II. FEATURES (pic. 1)
A – case of the welder
A1 – indicator light A3 – air exhauster nozzle
A2 – welding wire A4 – power cord
B – foldable lid
C – PE foil roll
III. INSTRUCTIONS FOR USE
Remove all packaging, take out the appliance and connect the fork of the supply chord
to a socket. The welder is supplied with a roll of PE foil. When welding the first bag, it is
necessary to follow the following process:
– Fold back the B lid and unwind a sufficient amount of the foil C so that it exceeds the
welder by 2 to 4 cm. Check if the welded spot is dry and clean , fold the lid B back
afterward. Make sure the foil is stretched straight without any creases on the welding
wire A2 before welding.
– Press on the lid B with both hands in order to make a perfect weld (pic. 2) and wait for
the indicator light A1 to turn off (approx. 10 sec). The indicator light signals the PE foil is
being welded.
– Remove the rest of the foil by tearing before folding back the lid B .
Air suction and bag welding
Fill the prepared bag to ¾ max. of its length (capacity) with food or anything you want to
keep fresh. Place the open end of the bag on the welding wire A2 so that the air suction
nozzle A3 is inside the bag‘s opening. Check for creases or folds in place of the future
weld. The straighter this area is, the better. Fold the lid B on and push lightly on the right
corner of the lid, which will trigger the air suction (you will hear the motor), hold the lid in
this position but do not push it all the way down.
GB
15 / 27