eta 0626, Инструкция по эксплуатации

Страница: 17 / 36

– Use this appliance only for the purpose for which it was designed as specified in this
user‘s manual. Never use the appliance for any other purpose.
– The producer does not undertake any responsibility for damage caused by improper use
of the appliance (e.g. injury, fire, etc. ) and its guarantee does not cover the appliance in
the case of failure to comply with the safety warning above.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A – humidifier (base)
A1 – foam filter cover (ETA062600110)
A2 – ultrasound converter
A3 – PTC heater
B
–
water tank
(ETA062600080)
B1 – lid with a baffle (ETA062600100)
B2 – handle
B3 – cap with a valve
B4 – vessel for aromatic additives (e.g. essential oils)
B5 – aroma car small filter (ETA062600090)
C – control panel
C1 – ON / OFF button
C2 – automatic mode
C3 – function of ionization
C4 – timer
C5 – humidification intensity setting
C6 – hot steam function
C7 – dimming / night mode
C8 – display
D – cleaning brush
III . PREPARATION FOR USE
Remove all packaging, take the humidifier out. Remove all adhesion foils, stickers or paper
from the humidifier.
Note
The ultrasound humidifier creates microscopic drops of water with the diameter of
about 1 – 5 μm using high-frequency oscillator. The ventilation system then blows
them out in the form of vapour (fog) into the room where they evaporate and thus
increase air humidity.
CONTROL
Connect the appliance to the mains by plugging the power cord into a wall outlet.
ON / OFF button (C1) – press to turn on the humidifier to the lowest intensity and cold
steam. Press repeatedly to switch off the humidifier.
auto mode button (C2) – press to activate the setting option automatic mode, in which
you can set the achievement and subsequent maintenance of
relative humidity in the room. The button reacts as follows
--% RH”→“45% RH”→“55% RH”→“60%RH”→…→“75% RH” →“--% RH
17
GB
/ 31