ET Hydrogen L/350, Инструкция по эксплуатации и техническому обслуживанию

Страница: 15 / 36

15
2) BEFORE ANY RE-FILL OPERATION, REMOVE THE BOOSTER TANK (FLUX)
ALWAYS FIRST, (Fig 1 # 7).
3) Remove the safety cap (Fig.1 # 2).
4) Through the use of a funnel, slowly pour the electrolyte previously prepared thought the
filling neck (Fig.1 # 3) and into the tank (Fig.5 # 46). The “MAX” yellow light (Fig.1 # 5) will
go out. If the “MAX” red light (Fig.1 # 6) does not shine after all the electrolyte has been
poured into the tank, add distilled or demineralized water until the light is illuminated.
DANGER
IT IS RECOMMENDED THAT NO WATER IS POURED WHEN THE RED LIGHT IS ON.
5) Put the safety cap back into place (Fig.1 # 2) and tighten it. Do not over tighten.
6)
Slide the switch (Fig.1 # 1) to the “O” off position.
IMPORTANT NOTE:
For the first startup of our ET systems, or for the yearly maintenance (once every year), the
machine must be filled or refilled with electrolyte solution.
For the daily refill it is mandatory to pour only demineralized (or distilled) water inside the
electrolyte tank
Pouring electrolyte solution daily will cause a crystallization inside the tank and
consequent obstructions of machines
’ hoses, potentially causing a general malfunction.
4.4 BOOSTER TANK FILLING
1) Loosen the handle knob (Fig.1 # 8) and remove the Booster Tank (Fig.1 # 7).
2)
Pour the deoxidizer liquid (see sec. 4.5) into the Booster Tank until it reaches the “MAX”
marked on the outside. Do not pour liquid beyond this level.
3)
The eventual electrostatic charge of your body may cause a spark and flame up the
liquid deoxidizer, this is to be avoided. Therefore take a moment to discharge your
electrostatic charge on another metal object before approaching the Booster Tank.
before approaching the Booster Tank while on its seat, you touch, for a moment with the
other hand, the Booster holder (Fig.1 # 9). Repeat this operation each time you perform the
Booster filling deoxidizer.
4) Place the Booster Tank back into place (Fig.1 # 7) and tighten the handle knob (Fig.1 # 8),
just enough. Do not overtighten in order to preserve the gaskets’ integrity.
4.5 PREPARING FLUX (DEOXIDIZER) LIQUID.