ET Hydrogen L/350, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 36

14
SECTION 4
Use
4.1 CONNECTION TO THE ELECTRIC CIRCUIT
Check that the main voltage corresponds to the voltage indicated on the plate at the rear of the
welder (Fig. 1 # 21). Test the electrical circuit grounding to make sure that is it efficient.
-
Slide the switch (Fig.1 # 1) to the “O” position.
- Insert power cable plug (Fig.5 # 31) into the current outlet.
4.2 PREPARING THE ELECTROLYTE
Pour 180 grams of KOH (Potassium Hydroxide) into a clean stainless-steel vessel and/or hard
plastic container that has been previously filled with 0,445 liters (0.118 US gal) of distilled or
demineralized water. If the vessel needs to be cleaned, wash it with tap water a few times, until it
becomes clean and after that, dry it with a rag. Stir immediately but gently, using a clean stainless-
steel implement, until the product is fully dissolved, producing a reaction that generates heat. Wait
until the solution has cooled down.
DO NOT USE DETERGENTS OR LIQUID SOAPS.
DO NOT PREPARE the electrolyte solution inside the machine tank. It must be prepared into an
external vessel BEFORE being introduced inside the machine tank.
DANGER
AVOID SPILLS. ALLOW COOLING TIME.
THE ELECTROLYTE IS HIGHLY CAUSTIC AND CAN CAUSE SERIOUS SCALDS TO THE
SKIN AND HUMAN BODY. WHEN HANDLING THIS PRODUCT, ALWAYS MAKE SURE THAT
A CONTAINER FULL OF WATER AND VINEGAR IS WHITHIN REACH, IN ORDER TO BE
ABLE TO WASH IMMEDIATELY ANY PART THAT COMES INTO CONTACT WITH THE
PRODUCT AND SUBSEQUENTLY RINSE CAREFULLY WITH RUNNING WATER.
THE USE OF PROTECTIVE CLOTHES, GLOVES, GLASSES, MASK FOR RESPIRATORY
TRACT, IS OBLIGATORY.
IF THE PRODUCT COMES INTO CONTACT WITH THE EYES, WASH AND RINSE THEM
REPEATEDLY AND IMMEDIATELY, THEN TAKE THE AFFECTED PERSON TO A FIRST AID
STATION.
4.3 TANK FILLING
1)
Slide the switch (Fig.1 # 1) to the “=” position; the green indicator light (Fig.1 # 12) and the
“MIN” yellow indicator light (Fig.1 # 5) on the control panel will be illuminated.