ET Hydrogen L/350, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 36

13
- During maintenance operations and repairs, protective clothing must be worn, i.e.
protective eyewear, gloves for preventing cuts and mask for respiratory tract protection.
- Do not use water jets to clean the machine.
SECTION 3
Transport and Installation
3.1 PACKAGING
The welder is wrapped up in a polythene film and subsequently packed in a three-layer waterproof
cardboard box sealed with adhesive tape and secured by a double strap.
3.2 SHIPPING
Whatever transportation method is used, (either by plane, sea or land) continental or
intercontinental, the machine tanks will be empty.
If REQUESTED or where PERMITTED :
The packaged electrolyte salts and/or bottled demineralized water, will be shipped according to
the rules, law and regulations of the machine’s destination (country).
3.3 UNPACKAGING
Make sure that:
- The welder has not suffered damage during transportation and, if necessary, report to the
manufacturer or authorized reseller.
3.4 POSITIONING
Set the welder on a solid and stable surface, away from heat sources. Allow at least 50 cm of free
space for the cooling louvres on the machine sides, for proper air circulation.
3.5 STORING
When the welder is in storage, the tank must be filled with electrolyte (Fig.5 # 46) and the machine
must be started for a few minutes at least once a month.
Avoid storing in humid places.