Mobil-PDi/MDi remote control
Doc. no. MA007828_00
28 / 34
EN
the touch panel (see above “5.1 Switching on and off and selecting a pro-
gram”).
To change the settings in programs 1 to 4:
Prerequisite:
• The program that you want to adjust is active.
1. Press the
button to activate simple programming mode.
The dark blue LED is lit.
2. Set the switch-off delay time, switching value and other parameters
using the buttons (see table in section 7.3.1).
3. Press the
button to exit simple programming mode.
The program is configured to your requirements.
The settings remain stored after a power cut. To undo the chang-
es, reset the detectors to the factory settings or enter the original
values in simple programming mode again.
7.3.4 Setting the touch commands
You can specify which touch commands are possible in a program. You can
adjust the following command combinations:
• Short touch: on/off. Long touch: no function.
• Short touch: on. Long touch: no function.
• Short touch: on/off. Long touch: Program selection mode.
To set the permitted touch commands:
Prerequisite:
• The program that you want to adjust is active.
1. Press the
button to activate simple programming mode.
The dark blue LED is lit.
The detector goes into programming mode.
2. Press the
button to activate touch command programming.
The purple LED is lit.
3. Click
•
the
button so that the detector can be switched on and off by
a short touch. It is not possible to change the program with a long
touch.
The LED is lit in green.
Short: on/off.
Long:
no function
