GB
37 / 44
MA01708100
Settings with the ESY Control app
7.2.8 Reset to default settings
This setting is used to reset all settings to the default settings. You can find
the default settings in chapter
"5.2 Default settings" on page 22
.
Acknowledgement:
The lighting switches on. The detector LED provides
various feedback signals during transmission. After the changes have been
completed, the green detector LED flashes three times to confirm this.
The lighting then switches off.
7.2.9 Test mode
In
< Test mode >
, you can test the detector's motion detection function
by walking through the field of detection. When test mode is activated,
the motion detector only detects movement and ignores the ambient light
conditions.
You can make required changes to the field of detection via the
< Motion
sensor sensitivity >
setting (see chapter
"7.2.6 Motion sensor sensitivity"
), mechanically using the supplied lens mask or by
the moveable lens (MD 200°) or the sensor head (MD 230° /
MD 280°). When test mode is active, no settings can be configured.
Setting options: < On > < Off >
Acknowledgement:
When test mode is active, the detector LED lights up in
turquoise constantly, and when movement is detected this briefly flashes
red. The switch-off delay time is two seconds. Then there is an idle period
of four seconds. During this time, motion detection is switched off. Once
test mode is no longer active, the green detector LED flashes three times to
confirm this.
7.2.10 Password protection
A personal password can be set to prevent unauthorised parties from
configuring the motion detector. The best way to use this setting is by
configuring a "Project" in the ESY Control app. This is the only way to
ensure that the new password is documented in a PDF report.
The motion detector has the password 0000 by default and is unprotected.
A new password must be set to activate password protection. After a new
