ESX QUANTUM Q-ONEv2, Руководство пользователя

Страница: 10 / 32

10
INPUT SENSITIVITY
Turn the controller INPUT LEVEL (Fig. 1,3) of the amplifier to the MIN position. Then turn the volume controller
of the head unit to 80 - 90% of its full setting. Now turn INPUT LEVEL clockwise until you hear some distortion.
Then turn back the INPUT LEVEL slightly until you hear a cleaner sound.
VARIABLE BASS BOOST
By using the controller BASS BOOST (Fig. 1,5) you are able to increase the bass enhancement from 0 to 12
dB. ATTENTION: Use the BASS BOOST wisely!
HIGH LEVEL INPUTS & AUTO TURN ON
The high level inputs under HIGH LEVEL INPUT (Fig. 1,2) is suitable to connect the device input with speak-
er wires, if your head unit is not equipped with pre-amplifier RCA outputs. Extend therefor every regarding
speaker cable from your head unit with appropriate speaker cables from your car audio retailer to the mounting
location of the amplifier. Then connect the each matching loudspeaker cable with the cables of the included
High Level Input jack.
CAUTION: Never use the high level inputs and the RCA inputs at the same time. This may damage the
device seriously.
Hence, the amplifier will also be turned on. As soon as the head unit will be turned off, the amplifier turns also
automatically off. In this case the turn-on connection REM (Fig. 2,2) is not needed.
NOTE: The Auto Turn On function usually works with 90% of all head units, because they are equipped with
”High Power”-outputs. Only with a few older and head units the Auto Turn On function is not working.
VARIABLE SUBSONIC FILTER
With the SUBSONIC controller (Fig. 1,7) you can adjust the lower crossover frequency, to filter the very low
frequencies to relieve the subwoofer or to generate a bandpass signal. If you don’t want to use this function,
turn the controller (Fig. 1,7) to the very left to the 10 Hz position.
NOTE: The adjusted value of the SUBSONIC (Fig. 1,7) should not be higher than the adjusted value of the
LOW PASS controller (Fig. 1,8). Otherwise no sound will be audible.
VARIABLE LOW PASS FILTER
Set the desired crossover frequency by using the controller LPF (Fig. 1,8). Thus to that only the frequencies
below the chosen crossover frequency will be amplified and the subwoofer plays more precisely and efficient.
BASS LEVEL REMOTE CONTROLLER
With the included bass level cable remote controller you are able to adjust the bass level e.g. out of the driver’s
seat. Connect the remote controller and the REMOTE connector (Fig. 1,6) with the enclosed cable.
PHASE CONTROLLER
The PHASE controller (Fig. 1,4) allows to adjust the phase between 0° and 180° to match the output signal
with the vehicle’s interior acoustic.