Esu LokPilot Fx V4.0, Инструкция по эксплуатации

Страница: 32 / 76

32
Programming
8.2.3.1. Changing to the Programming Mode
Enter the programming mode with the 6020/6021:
The throttle must be set to „0“. No other locomotives may be on
on the layout. Watch out for flashing signals of the locomotive!
Press the „Stop“ and „Go“ buttons of the 6021 simultaneously
•
until a reset has been triggered (alternately pull the mains plug of
the transformer). Press the „Stop“ button in order to switch off
the track voltage. Enter the current decoder address. If you do not
know the current address, simply enter „80“.
Activate the change-of-direction button (turn the throttle knob to
•
the left beyond the arrestor until you hear a click sound), hold it in
this position and then press the „Go“ button.
Please bear in mind that the 6020/6021 only permits you to enter
values from 1 to 80. The value 0 is missing. Always enter „80“
instead of „0”.
8.2.3.2. Short Mode
The decoder is in the short mode (the headlights flash periodically
in brief intervals).
Now enter the number of the CV that you want to adjust e.g.:
•
„01“. Always enter this number with two digits.
For confirmation activate the change-of-direction routine (now
•
the lights flash twice very quickly).
Now enter the new value for the desired CV, e.g.: 15 (two digits).
•
For confirmation activate the change-of-direction routine (now •
the lights light up for about one second).
Then you can enter other CVs as desired.
•
Selecting „80“ allows you to exit the programming mode. Alter- •
nately you can switch off the track voltage and then on again
(press the „Stop“ button on the 6021, then the „Go“ button).
8.2.3.3. Long Mode
You access the long mode by entering the value 07 in CV 07 while
in the short mode. The decoder confirms the change to the long
mode by slowly flashing lights.
Enter the hundred-digit and the ten-digit (decade) of the CV that
•
you want to change. Example: If you want to adjust CV 124, you
enter „12“.
For confirmation activate the change-of-direction routine (now
•
the lights flash periodically: long – short – long – short - etc.)
Now enter the unit of the CV („04“ in this example).
•
For confirmation activate the change-of-direction routine. Now •
the decoder expects the entry of the CV value. The lights flash
periodically: long – short – short).
Now enter the hundred-digit and the ten-digit (decade) of the
•
new CV value (as a two-digit number). Example: You want to write
the value 135. Therefore, you enter „13“.
For confirmation activate the change-of-direction routine. Now
•
the lights flash periodically: long – short – short – short).
Now enter the unit of the new CV value as a two-digit number
•
(„05“ in this example).
For confirmation activate the change-of-direction routine (now
•
the lights light up for about one second).
Now you can adjust more CVs in long mode.
•
Exit the long mode by switching off the track voltage and then •
on again (press the „Stop“ button on the 6021, then the „Go“
button).