GSM-INTERCOM OPERATION MANUAL
V20170702
4) Switch the on-board Power switch to "ON"
position and allow 20-30 seconds for the unit to
boot up and detect the network. Once successful
connection has been made, the display panel will
show the "- - - - -" at each LED panel.if the GSM
network reception is weak,then will only show two
to three Dash lines.
5) To confirm the SIM card is working properly
and you can use your mobile phone to call the
Device number, the box will reject the calling to
confirm that is working properly.
6) Maintaining
the
internal wiring clean,
reliable,especially the GSM antenna should be
along the side or use the double-sided tape to stick
the antenna at the top of the box
ABOUT
THE
RELAY
OUTPUT
GSM-APARTMENT Board has two relay outputs.
Both relay can be controlled for momentary and latching operation.
Only Relay output1 can be controlled with authorized number calling in to trigger the output
Both relay can be controlled with SMS command
Both relay can be controlled during phone connection to the intercom with the remote phone’s keypad.
PROGRAMMING
SYSTEM
PASSWORD
Programming is carried out by sending SMS texts to the unit.
Each SMS must start with the PASSWORD, default 123456, in the following format #PWD123456#, followed
immediately by a command
#PWD
Password
.
This command must always come first 6 digits as a password.
The standard default one, when the device comes from the factory, is 123456.
In all the following examples we will use 123456 as an example of password.
#CAP
Change
Password
.
Use this command to change the password with a new one that you will chose for your device ( don't forget it or
you will have to send the unit back to us to reset it, and this has a cost )
The #CAP command must be issued 2 times to be sure you don't digit a wrong one.
OF course it must be preceded by the old password.
For example, to change the password 123456 to the new password 333444 you need to send the following SMS:
#PWD123456#CAP333444#CAP333444
Acknowledge SMS: PWD SETUP OK
If you wrote correctly, or an Error message if you made a mistake.
If the old password is entered wrong,then conformation would be : Error Old Password
