9.
Tie control wires to the rudder and elevator horns.
10.
Pull wires and tie to the servo horns.
14.
Assemble tailgear struts(G19-G20) and tail wheel with
bolts and nuts.
Put up rubber band. Make two circles with one rubber band.
15.
Assemble maingear struts(G6-G8) and main wheel with
steel rod, bolts and nuts.
Put up rubber bands. One for fore hook, two for rear hook.
Page 8
16.
Glue tray for battery(F45).
17.
Glue tray for balance weight(F46).
PRE-FLIGHT CHECK
CG.
Check CG. (CG location is shown on the drawing.)
Control Throws.
The following control throws are recommended starting
points. After you are familiar with this plane, you may
increase, or decrease.
- Elevator : 17.5mm(11/16”) up and 12.5mm(1/2”) down.
- Rudder : 33mm(1-5/16”) right and left.
