70
DESCRIPTION
Set IP Mode
You can set pre-paid card data for easier use.
After the “
Flash time
” programmation “SET 4 IP” on the display for ten
seconds is displayed. In case you do not push any key within these ten seconds,
you have to push again the “ SET/STORE” key and the “UP” or “DOWN” ones
till “SET 4 IP” is displayed.
The “on” or “off” mode is selected by pressing “UP” or “DOWN” key and
is confirmed by “SET/STORE” key.
Press “SET/STORE” key to confirm when “AUTO IP ON” is selected.
“INPUT CODE” is then displayed.
Input the service number, card’s number and the secret number for an
IP card. “Pause” key is used when there is a voice announcement.
“Delete” key is used to cancel a wrong digit.
To confirm above settings by pressing “SET/STORE” key again.
Note: When this setting is completed, every time you dial the
number headed with “0” using on-hook pre-dialing method
or dial back incoming call headed with “0” or dial back
dialed call headed with “0”, the stored IP code will be dialed
first.
Set Brightness
After the “
Set IP mode
” programmation “SET 5 LCD” on the display for ten
seconds is displayed. In case you do not push any key within these ten seconds,
you have to push again the “ SET/STORE” key and the “UP” or “DOWN” ones
till “SET 5 LCD” is displayed.
Press “SET/STORE” key to conform. “LCD X” is displayed.
X (1,2,3,4,5) is selected with “UP” or “DOWN” key.
Press “SET/STORE” key again to confirm the setting.
Set Ringer on/off
After the “
Brightness
” programmation “SET 6 no ring” on the display for ten
seconds is displayed. In case you do not push any key within these ten seconds,
