4. Setup & installation
4.1. Software installation
The enclosed CD contains all necessary application files and drivers to install and run the evaluation system on your computer.
4.1.1. SW installation on PC
System requirements (refer also to Table 2):
PC with Windows XP or higher
Before you start the installation process, close all running applications.
Figure 10: PC installation file on CD
Start the installation by executing the installer “epc600 epc610 Evaluation Kit Install_Vx.x.exe”.The installer routine will load the application
software as well as the necessary drivers on your system.
After completion of the software installation, connect the evaluation kit through the connector J6 USP FS to your PC with the enclosed
USB cable. Make sure that the power supply selection switch on the evaluation kit is switched to “USB” ( Figure 11).
Figure 11: PC USB power supply setting
The PC will detect the new hardware and start the Windows hardware installation assistant. Choose the default option “Install software au -
tomatically” to complete the installation.
Start the application with the link “epc600 epc610 Evaluation Kit” that has been added to your program shortcut menu.
Disconnect the USB cable before attaching a camera module and proceed with chapter 4.2. Running the epc610 application.
© 2014 ESPROS Photonics Corporation
Characteristics subject to change without notice
11 / 26
Manual epc610_Camera - V1.5
www.espros.ch
PC USB
Power Supply
Switch to
“USB”